K Tahoe 4WD V8-4.8L VIN V (2000)
Intake Manifold: Service and Repair
Engine Sight Shield Replacement
Removal Procedure
1. Remove the sight shield bolts.
2. Remove the sight shield from the engine.
3. Remove the sight shield mounting bracket and bolts (if required).
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the sight shield mounting bracket and bolts.
Tighten the bracket bolts to 5 Nm (44 inch lbs.).
Notice: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector.
Loss of engine performance or engine damage may result.
2. Install the engine sight shield and bolts to the bracket.
Tighten the bolts to 10 Nm (89 inch lbs.).
