K Tahoe 4WD V8-4.8L VIN V (2000)
9. When using method 1 do the following:
10. Install the J 34614 in the seal lip.
10.1. Place the seal lip over the compressor shaft.
10.2. Push the seal (1) into place using a rotary motion.
11. When using method 2 do the following:
12. Place the J 34614 over the end of the compressor shaft.
13. Slide the new seal (1) onto the shaft using a rotary motion until the seal stops.
13.1. Ensure that the seal contacts the O-ring. Do not dislodge the O-ring. Disengage the installer from the seal.
13.2. Remove the J 23128-A and the J 34614.