K Tahoe 4WD V8-4.8L VIN V (2000)
may cut or damage the wire.
5. Install the coil assembly retaining ring. Verify that the ring (1) is firmly seated in the groove on the upper shaft assembly (2).
6. Pop the wire harness assembly (4) into the wire strap (5).
7. Install the wire harness strap (2) into the upper tilt head assembly (1).
8. Install 3 wire harness straps (3) to the wire harness assembly.
9. Install the multi-function switch lever.
10. Install the upper and lower steering column trim covers.
11. Install the tilt lever (if equipped).
12. Install the steering wheel assembly.
13. Enable the SIR system.
