K Tahoe 4WD V8-4.8L VIN V (2000)
7.
Connect the driver yellow 2-way connector (2) to the vehicle harness yellow 2-way connector located under the IP. Install the CPA and the clip to
the cross-vehicle P brace.
8.
Install the AIR BAG fuse into the fuse block.
9.
Install the fuse box door panel to the P.
10.
Staying well away from all air bags, turn ON the ignition. The AIR BAG indicator will flash seven times, then turn off.
11.
Connect the Tech 2 to the vehicle and clear all DTCs.
12.
Perform the Diagnostic System Check - SIR if the AIR BAG indicator lamp does not operate as described. Refer to published service information
in the SIR subsection for other conditions.
