K Tahoe 4WD V8-4.8L VIN V (2000)
NOTE: Refer to the Fastener Notice in Cautions and Notices.
IMPORTANT: Always use a torque wrench in order to obtain the proper torque.
2. Install the accelerator pedal mounting bolts.
Tighten
Tighten the accelerator pedal mounting bolts to 20 N.m (15 lb ft).
3. Connect the electrical connector to the accelerator pedal sensor module.
4. Test for proper throttle opening and closing range by operating the accelerator pedal and monitoring the throttle angles using a scan tool. The
accelerator pedal should operate freely without binding between full closed throttle and Wide Open Throttle (WOT).
5. Inspect the carpet fit under the accelerator pedal.
6. Install the left IP lower closeout insulator panel.
