chevrolet Workshop Repair Guides

Chevrolet Workshop Service and Repair Manuals

Technician Safety Information|Page 10721 > < Diagram Information and Instructions|Page 10718
Page 1
background image

Starter Motor: Technician Safety Information

CAUTION:  Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be
OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal,
also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its
components.

CAUTION:  Batteries produce explosive gases, contain corrosive acid, and supply levels of electrical current high enough to cause burns.
Therefore, to reduce the risk of personal injury when working near a battery:

-

Always shield your eyes and avoid leaning over the battery whenever possible.

-

Do not expose the battery to open flames or sparks.

-

Do not allow the battery electrolyte to contact the eyes or the skin. Flush immediately and thoroughly any contacted areas with water an
get medical help.

-

Follow each step of the jump starting procedure in order.

-

Treat both the booster and the discharged batteries carefully when using the jumper cables.

Technician Safety Information|Page 10721 > < Diagram Information and Instructions|Page 10718