K Tahoe 4WD V8-4.8L VIN V (2000)
25. If all of the gear positions cannot be achieved, the shift cable must be readjusted. Perform steps 26 through 28.
26. Pull back the white plastic cover (1) on the center connector.
27. Pull up on the center tabs of the lock button (2).
28. Repeat steps 18 through 22.
Important:
^
Inspect shift lever pin for corrosion and replace if necessary.
^
The shift cable is a two piece shift cable.
The front or rear half of the shift cable can be removed without removing the other half.
Perform the installation procedure that applies to the installation of that half of the shift cable.
29. Position the steering column shift lever to the park position.
30. Raise the vehicle. Refer to Vehicle Lifting.
31. Ensure the transmission manual shaft is positioned to the mechanical park.
32. Install the shift cable to the transmission bracket.
33. Install the retainer securing the shift cable to the transmission bracket.
34. Install the shift cable end to the transmission shift lever ball stud.
