K Tahoe 4WD V8-5.7L VIN R (1996)
CAUTION: Do not use anti-seize type products on the caliper V-ways and anchor plate guide way surfaces. These products are not lubricants
and result in high caliper slide forces, which can cause increased wear of the brake pads.
Installing The Caliper Support Key
3. Spring (4) and support key (3). Use a brass punch and hammer to drive the support key in place.
4. Caliper lock mounting bolts. The boss on the bolt must fit into the circular cutout in the key.
^
Tighten bolts to 20 Nm (15 lb. ft.).
5. Brake hose.
^
Tighten brake hose bolt to 45 Nm (33 lb. ft.).
6. Bleed brake system. Refer to Hydraulic System Service and Repair.
7. Tire and wheel.
8. Lower the vehicle.
CAUTION: Before moving the vehicle, pump the brake pedal several times to make sure it is firm. Do not move the vehicle until a firm pedal is
obtained. Check the brake fluid level in the master cylinder after pumping the brakes.
Rear Disc Brakes
CALIPER
Remove or Disconnect
1. Two-thirds of the brake fluid from master cylinder.
2. Raise vehicle and support with safety stands.
3. Mark relationship of wheel to hub.
4. Tire and wheel.
Compressing The Caliper Piston
5. Position a C-clamp and tighten until piston bottoms in bore.
6. C-Clamp.
7. Brake hose.
