K Tahoe 4WD V8-5.7L VIN R (1996)
Fuel Supply Line: Service and Repair
Fuel Vapor Pipes and Hoses
Diagram
Diagram
Removal Procedure
NOTE: If the nylon pipes become kinked, and cannot be straightened, replace them.
-
Do Not attempt to repair sections of nylon pipes. If damaged, replace.
-
When replacing the vapor pipes, always replace them with original equipment or parts that meet GM specifications.
-
When replacing the vapor hoses, always replace them with original equipment or parts meeting GM specifications. Use only reinforced
fuel-resistant hose identified with the word Fluoroelastomer or GM 6163-M on the hose.
1. Remove the hardware retaining section of the pipe to be replaced. Note the location of attaching hardware for installation.
2. Remove the section of the pipe and hoses.
3. Inspect the hoses for cuts, swelling, cracks and distortion. Replace as required.
4. Inspect the pipes for holes, kinks, and cracks. Replace the sections as required.
Installation Procedure
Important:
-
Follow the same routing as the original pipes and hoses.
-
Secure the pipes and hoses to prevent chafing.
1. Install the section of the pipe and hoses.
2. Install the hardware retaining section of the pipe being replaced.
