Lumina L4-151 2.5L (1991)
Case: Service and Repair
4T60-E Automatic Transaxle
CASE SIDE COVER PAN AND/OR GASKETS 4T60-E
Fig. 4, Valve body assembly
TOOLS REQUIRED:
^
J 28467-A Engine Support Fixture
^
J 28467-90 Engine Support Fixture Adapter
^
J 36462 Engine Support Adapter Leg
REMOVE OR DISCONNECT
1. Air cleaner assembly.
2. Negative battery cable.
^
Install J 28467-A, J 28467-90 and J 36462.
3. Torque struts at engine mounts.
4. Two crossover pipe-to-left manifold bolts.
5. Loosen crossover pipe-to-right manifold clamp.
NOTICE: Do not pry on crossover heat shield. If shield is bent, heat damage to other components may occur.
6. Two bolts at top of transaxle mount bracket. Pry crossover pipe to allow removal of front bolts.
^
Raise vehicle and suitably support.
7. Left front tire and wheel assembly.
8. Left front brake caliper and bracket.
9. Four bolts at hub and bearing assembly.
10. Left drive axle.
11. Left lower ball joint.
12. Left inner fender splash shield.
CAUTION: Failure to disconnect the intermediate shaft from the rack and pinion stub shaft can result in damage to the steering gear and/or
intermediate shaft. This damage may cause loss of steering control which could result in personal injury.
