Lumina L4-151 2.5L (1991)
3.
With the run channel removed, make sure the run channel retainer retaining screws are tight (See Figure 5).
4.
Using bedding and glazing compound, run a 5 mm bead around the inboard edge of the retainer.
5.
Using bedding and glazing compound, fill the cavity in the upper rear corner of the door frame (See Figure 3, View A). Also fill the cavity
in the upper corner above the mirror where the run channel retainers meets the mirror.
6.
Spray window run channel with glass cleaner, for ease of installation.
7.
Reinstall the window run channel, using a plastic trim stick to ensure that the run channel is fully seated in the retainer.
Labor Operation Table
V.
Windnoise at rear door window run channel to door frame.
1.
Lower door glass.
2.
Remove the front and top portion of the run channel from the retainer by pulling down and outboard on the run channel.
3.
With the run channel removed, make sure the run channel retainer retaining screws are tight (see Figure 5).
