Lumina V6-191 3.1L VIN T MFI (1993)
4.
Make repair.
When using a new terminal:
a.
Slip cable seal away from terminal (if seal exist).
b.
Cut wire as close to terminal as possible.
c.
Slip a new cable seal onto wire (if necessary).
d.
Strip 3/16" (5 mm) of insulation from wire.
Figure 17
e.
Crimp a new terminal to the wire (Figure 17).
f.
Solder with rosin core solder.
g.
Slide cable seal toward terminal (if equipped with a seal).
h.
Crimp cable seal and insulation (if equipped with a seal, see Figure 17).
i.
Apply grease to connectors outside the passenger compartment where the connector originally was equipped with grease.
To re-use a terminal or lead assembly, see previous steps c through i for repairs. Be sure to keep cable seal (if equipped) on terminal side of splice.
5.
Insert lead from the back until it catches.
Figure 18
Figure 19
6.
Install TPA's, CPA's and/or secondary locks, if equipped (see Figures 18 & 19).
Basic Troubleshooting Guide
TROUBLESHOOTING GUIDELINES
Without a basic knowledge of electricity, it will be difficult to use the diagnostic procedures contained in this section. You should understand the
basic theory of electricity and know the meaning of voltage, current (amps) and resistance (ohms). You should understand what happens in a
circuit with an open or a shorted wire. You should be able to read and understand a wiring diagram. The following four-step troubleshooting
