Lumina V6-191 3.1L VIN T MFI (1993)
Timing Cover: Service and Repair
Engine Front Cover Oil Seal Replace
REMOVAL
1. Remove crankshaft balancer. Refer to Crankshaft Balancer / Service and Repair. See: Cylinder Block Assembly/Crankshaft Balancer/Service
and Repair
CAUTION Be careful not to damage the crankshaft.
2. Remove front cover oil seal.
NOTE Pry out seal with a suitable tool such as a large screwdriver. Refer to instructions supplied with replacement part.
3. Inspect crankshaft and front cover for scratches.
Front Cover Aligner And Oil Seal Installer
INSTALLATION
1. Lubricate seal with clean engine oil.
2. Install seal in front cover with lip facing the engine using J 35468.
3. Install crankshaft balancer and torque retaining bolt to 103 Nm (76 lb. ft.).
4. Inspect for leaks.
