Lumina V6-191 3.1L VIN T MFI (1993)
Housing Cover And Turn Signal Switch Removal
Buzzer Switch Wires, Removal
Remove or Disconnect
Tool Required: J 35689-A Terminal Remover.
1. Nut retainer and jamnut (1).
2. Steering wheel.
3. Turn signal cancel cam assembly (2).
4. Hazard knob screw (10).
5. Hazard warning knob (9).
Important: Position turn signal switch (11) so that turn signal switch screws (7) and housing cover screw (41) can be removed through openings in
switch.
6. Housing cover screw (41). (This screw is longer and blue in color.)
7. Column housing cover (8).
8. Wiring protector (20) from opening in "IP" bracket on jacket and bowl assembly (23) and separate from wires.
9. Pivot and pulse switch connector (19) from ignition and dimmer switch (37).
10. Pivot switch screw (18).
11. Pivot and pulse switch assembly (19).
12. Turn signal switch screws (7).
13. Turn signal switch connector (11) from ignition and dimmer switch assembly connector (37).
14. Seventeen-way secondary lock from turn signal connector (11).
15. Wires on buzzer switch assembly (21) from turn signal connector with J 35689-A, wrap wire ends with tape to protect during removal and
installation.
16. Turn signal switch assembly (11) from column.
Install or Connect
