Lumina V6-191 3.1L VIN T MFI (1993)
Housing Cover And Turn Signal Switch Removal
Buzzer Switch Wires, Removal
Remove or Disconnect
Tool Required: J 35689-A Terminal Remover.
1. Nut retainer and jamnut (1).
2. Steering wheel.
3. Turn signal cancel cam assembly (2).
4. Hazard knob screw (6).
5. Hazard warning knob (5).
Important: Position turn signal switch (7) so that turn signal switch screws (3) and housing cover screw (41) can be removed through openings in switch
.
6. Housing cover screw (41). (This screw is longer and blue in color.)
7. Column housing cover (4).
8. Shoe pin retainer cap (8).
9. Wiring protector (16) from opening in "IP" bracket on jacket and bowl assembly (19) and separate from wires
10. Pivot and pulse switch connector (15) from ignition and dimmer switch(36).
11. Pivot switch screw (14).
12. Pivot and pulse switch assembly (15).
13. Turn signal switch screws (3).
14. Turn signal switch connector (7) from ignition and dimmer switch assembly connector (36).
15. E & C module(37) from turn signal switch assembly (7), if so equipped, as follows:
-
Remove tape and separate module from wire harness.
-
Depress tab on connector and gently separate module from connector.
16. Seventeen-way secondary lock from turn signal connector (7).