Lumina V6-191 3.1L VIN T MFI (1993)
Brake Bleeding: Service and Repair
With ABS System
Prior to Bleeding
BLEEDING SYSTEM
NOTICE: Prior to bleeding the brakes, the front and rear displacement cylinder pistons must be returned 'to the top most position. Using a Tech 1 or
T-100 (CAMS), select F5: Motor Rehome. Motor rehome function cannot be performed if current DTCs are present. If DTCs are present, the vehicle
must be repaired and DTCs cleared before performing the motor rehome function.
Start engine and allow it to run for at least 10 seconds (with foot off brake), this will cause the ABS to initialize itself. Make sure the ABS indicator lamp
is "OFF" after about 3 seconds. If the lamp remains "ON", a Tech 1 must be used to diagnose the illumination of the indicator lamp. If lamp goes "OFF"
and stays "OFF," repeat this procedure one more time. Now using a Tech 1 or T-100 (CAMS), enter the manual control function and "Apply" the front
and rear motors. The entire brake system should now be rebled following either "Pressure Bleeding" or "Manual Bleeding."
NOTICE: Use only DOT 3 brake fluid from a clean, sealed container. Do not use fluid from an open container that may be contaminated with water. Do
not use DOT 5 brake fluid.
Manual Bleeding
Attaching Bleeder Tube
Note: Use only DOT 3 brake fluid from a clean, sealed container. Do not use fluid from an open container that may be contaminated with water. Do not
use DOT 5 brake fluid.
Important
^
In the following steps, use a suitable container and/or shop cloths to catch fluid and prevent it from contacting any painted surfaces.
Clean
^
Fluid reservoir cover and surrounding area.
Remove or Disconnect
^
Fluid reservoir cover.
Inspect
^
Fluid level in reservoir and fill to the correct level if necessary.
Install or Connect