Lumina V6-191 3.1L VIN T MFI (1993)
3. Support frame using jack stands.
4. Rear frame mount bolts and lower rear of frame about 128 mm (5 inches).
5. Retaining clip from steering gear.
6. Loosen pressure pipe from steering gear and power steering pump.
7. Pressure pipe.
Inspect
^
O-rings, replace as necessary.
Install or Connect
1. Pressure pipe.
2. Pressure pipe at steering gear and power steering pump.
3. Retaining Clip to steering gear.
4. Raise frame and install rear frame bolts.
CAUTION: When installing the intermediate shaft, make sure the shaft is seated prior to pinch bolt installation. If the pinch bolt is
inserted into the coupling before shaft installation, the two mating shafts may disengage.
5. Intermediate steering shaft pinch bolt to steering gear.
6. Lower vehicle.
7. Fill system.
8. Bleed the system.
Inspect
^
For leaks.
