Lumina V6-191 3.1L VIN T MFI (1993)
Important: All fasteners in the following steps must be firmly seated before being tightened to specified torque.
1. Turn signal switch assembly (11).
Important: Position turn signal switch (11) 50 that turn signal switch screws (7) and housing cover screw (41) can be installed through openings in
switch.
2. Turn signal switch screws (7) and torque to 2.3 Nm (20 lb. in.).
.
Wires from buzzer switch assembly (21) to turn signal switch connector (11) as follows:
-
Light green wire in location "9."
-
Tan/black wire in location "10."
4. Seventeen-way secondary lock to turn signal connector (11) and snap in place.
5. Turn signal connector (11) to ignition and dimmer switch connector (37) and snap in place.
6. Pivot and pulse switch assembly (19).
7. Pivot switch screw (18) and torque to 2.3 Nm (20 lb. in.).
8. Pivot switch connector (19) to ignition and dimmer switch connector (37) and snap in place.
9. Wiring protector (20) as follows:
-
Wrap protector (20) around all wires passing through "IP" bracket opening.
-
Close protector so that interlocking grooves engage.
-
Slide wiring protector (20) into "IP" bracket opening on jacket and bowl assembly (23) and snap in place.
10. Column housing cover (8).
11. Housing cover screw (41) and torque to 2.3 Nm (20 lb. in.).
12. Hazard warning knob (9).
13. Hazard knob screw (10) and torque to 0.8 Nm (7 lb. in.).
14. Lubricate bottom side of cancel cam (2) with synthetic grease. (Reference grease service kit.)
^
Turn signal cancel cam assembly (2).
15. Steering wheel.
16. Jam nut (1), torque to 41 Nm (30 lb. ft.) and secure with nut retainer.
