Lumina V6-191 3.1L VIN T MFI (1993)
12. Adjust jack stand to lower left side of frame.
13. Bolts/screws holding engine wiring harness to transaxle case.
14. Transaxle oil cooler lines at transaxle.
15. Bolts/screws attaching bracket to transaxle.
16. Bracket.
INSTALL OR CONNECT
1. Bracket.
2. Bolts/screws attaching bracket to transaxle.
TIGHTEN
^
Rear bolt/screw to 85 Nm (63 lb. ft.).
^
Front bolt/screw to 48 Nm (35 lb. ft.).
3. Transaxle oil cooler lines at transaxle.
4. Bolts/screws holding engine wiring harness to transaxle case.
5. Raise left side of frame and install new frame to body bolts/screws.
6. Nuts attaching bracket to mount.
TIGHTEN
^
Nuts to 43 Nm (32 lb. ft.).
CAUTION: When installing the intermediate shaft make sure the shaft is seated prior to pinch bolt installation. If the pinch bolt is inserted
into the coupling before shaft Installation, the two mating shafts may disengage.
7. Pinch bolt at intermediate steering shaft.
8. Splash shield.
9. Tire and wheel.
10. Lower vehicle.
11. Left-hand torque strut bracket.
12. Transaxle bracket to bolt/screw.
TIGHTEN
^
Bolt/screw to 48 Nm (35 lb. ft.).
13. Remove J 28467-A and J 36462.
14. Negative battery cable.
15. Air cleaner.
Transaxle Mount
TRANSAXLE MOUNT
