Lumina V6-191 3.1L VIN T MFI (1993)
2. Lock module rod cover.
3. All rods attached to lock.
4. Rivets.
5. Lock.
Install or Connect
1. Lock.
2. Rivets.
3. All rods disconnected in step 3 of removal procedure.
4. Lock module rod cover.
5. Lock module.
Coupe
Door Lock Module
The automatic door lock system has an actuator in each door which actuates the lock through a linkage. The system is actuated by the chime module in
the convenience center or by any door lock switch. All doors lock or unlock at the same time except when the actuator is manually activated by a lock
rod. Each actuator has an internal circuit breaker which may require one to three minutes to reset.
Remove or Disconnect
1. Door trim panel.
2. Water deflector.
3. Two screws on opposite corners of actuator.
4. Electrical connector.
5. Actuator by disengaging from linkage.
Install or Connect
1. Actuator to linkage.
2. Electrical connector.
3. Screws.
Inspect
^
For proper operation by cycling system.
4. Water deflector.