Lumina V6-204 3.4L DOHC (1991)
3. Unlock booster (32) from cowl as shown in the illustration.
^
Attach J-22805-01 (34) to booster (32) with nuts (33).
Tighten
^
Nuts to 27 Nm (20 lbs ft).
^
Use a screwdriver (35) to pry locking tab (36) on booster out of locking notch (37) on mounting flange. At the same time turn the booster
counterclockwise with a wrench (38) on J-22805-01.
^
Do not attempt to remove booster (32) until pushrod (29) is disconnected from the brake pedal.
4. Booster push rod (29) from brake pedal.
5. Remove booster (32).
^
Take care not to damage insulator boot mounted on the front of dash when removing/installing pushrod (29) eye through hole.
Install or Connect
1. Attach J-22805-01 (34) to booster (32) with nuts (33).
Tighten
^
Nuts to 27 Nm (20 lbs ft).
2. Position booster (32) on cowl, slightly counter-clockwise from final installation position, so that locking flanges on booster and mounting plate
engage.
^
Take care not to damage or dislodge insulation boot when passing pushrod (29) eye through hole.
3. Booster pushrod (29) to brake pedal.
4. Turn booster (32) clockwise with wrench (38) on J-22805-01 (34).
^
It is not necessary to use screwdriver (35) on locking tab (36) as shown to install booster. When correctly installed, locking tab will slide up
flange and snap in locking notch (37).
^
Make sure locking tab (36) is fully engaged in locking notch (37).
5. Master cylinder (31) to booster (32) with attaching nuts (33)
Tighten
^
Nuts to 27 Nm (20 lbs ft).
