Lumina V6-204 3.4L DOHC (1991)
FIGURE 1
2. Measure for location and drill a 6.3 mm (1/4") diameter hole above and forward of the present location of the hose clip using the dimensions, shown
in View A of Figure 1.
3. Move the hose clip to the new location and install the coolant reservoir.
NOTICE:
BEFORE INSTALLING THE RESERVOIR ON 3.4L (LQ1) ENGINE CHECK THE RESERVOIR HOSE FOR DAMAGE. IF HOSE IS
DAMAGED, REPLACE THE HOSE.
4. To verify that the reservoir is properly installed in the two lower retaining tabs on the 3.4L (LQ1) engine, continue on with the following steps for