Lumina V6-204 3.4L DOHC (1991)
Correction # 2.
INFORMATION AND PROCEDURE FOR CORRECTION # 2
When the reservoir is properly mounted in the two lower retaining tabs there should be a clearance of 14 mm (9/16") between the reservoir hose, at the
bottom of the reservoir, and the A/C compressor pulley. This is very difficult to see and verify from the top underhood positon. For that reason, the
following steps should be taken.
1. Raise the vehicle.
2. At the RH front wheel well, remove enough of the plastic retainers (push pins) in the inner splash shield to allow hand clearance into the engine
compartment.
3. With your hand, feel for the reservoir being in the two lower retaining tabs, as shown in Figure 1.
4. Use your finger to estimate the clearance between the hose and the compressor pulley of 14 mm (9/16"). If, in your judgment, the clearance is not
adequate, try to tighten the hose routing between clips and/or use plastic tie (chicken band) to obtain the necessary clearance.
5. Install splash shield retainers.
6. Lower the vehicle.
Labor Operation:
T1744
Labor Time:
Condition # 1 Both Engines
0.3 Hours
Condition # 2 3.4L (LQ1) Engine
0.2 Hours
Add Time For Reservoir Hose Replace
0.2 Hours
Trouble Code:
92