Lumina V6-204 3.4L DOHC (1991)
INSTALL OR CONNECT
1. Generator and loosely install all mounting bolts. Tighten Generator lower mounting bolt to 83 Nm (61 ft lb).
^ If replacement generator does not fit, remove adhesive-backed shim from rear generator bracket (see figure).
2. Connector and wires to generator.
3. Right-hand engine splash shield.
4. Drive axle to transaxle.
5. Lower ball joint to lower control arm.
6. Tire and wheel assembly.
7. Lower vehicle.
8. Power steering pipe retaining clip nut to upper generator stud.
9. Serpentine belt.
10. Coolant recovery reservoir.
11. Negative battery cable. Tighten Cable to 15 Nm (11 ft lb).
12. Air cleaner assembly.
Manual Transaxle
Generator Shim - 3.4L Engine.
Generator Shields