Lumina V6-204 3.4L DOHC VIN X SFI (1996)
Manifold Absolute Pressure (MAP) Sensor: Description and Operation
MAP Sensor Service
DESCRIPTION
The Manifold Absolute Pressure (MAP) sensor responds to changes in intake manifold pressure (vacuum). The MAP sensor signal voltage to the PCM
varies from below 2 volts at idle (high vacuum) to above 4 volts with the key ON, engine not running or at wide-open throttle (low vacuum).
The MAP sensor is used to determine manifold pressure changes while the linear EGR flow test diagnostic is being run (refer to DTC P0401), to
determine engine vacuum level for other diagnostics and to determine barometric pressure (BARO).
If the PCM detects a voltage that is lower than the possible range of the MAP sensor, DTC P0107 will be set. A signal voltage higher than the possible
range of the sensor will set DTC P0108. An intermittent low or high voltage will set DTC P1107 or P1106 respectively.
The PCM can also detect a shifted MAP sensor. The PCM compares the MAP sensor signal to a calculated MAP based on throttle position and various
engine load factors. If the PCM detects a MAP signal that varies excessively above or below the calculated value, DTC P0106 will set.
