Lumina V6-204 3.4L DOHC VIN X SFI (1996)
^
Tool Required:
-
J 22610 Service Boot Clamp Installer
-
Or Equivalent
REMOVE OR DISCONNECT
1. Do all steps of OUTER TIE ROD under "REMOVE OR DISCONNECT."
2. Hex jam nut (7) from inner tie rod assembly (12).
3. Tie rod end clamp (8).
4. Boot clamp (11) with side cutters and discard.
Important: Mark location of breather tube (35) on gear assembly (30) before removing tube (35) or rack and pinion boot (10).
5. Rack and pinion boot (10) and breather tube (35).
INSTALL OR CONNECT
1. New boot clamp (11) onto rack and pinion boot (10).
