Lumina V6-3.1L VIN J (2000)
Front Bumper Cover / Fascia: Service and Repair
Front Bumper Fascia Molding Replacement
Front Bumper Fascia Molding Replacement
Front Fascia Molding End Loose
Tools Required
J 25070 Heat Gun
Important: The front fascia moldings are attached to the bumper fascia with adhesive tape. To ensure a good replacement of new or old
moldings, the panel surface should be warmed to 21°C to 32°C (70°F to 90°F), clean, and free of any wax or oily film.
1. Wash the affected area with soap and water and wipe dry. Wipe the panel and the adhesive side of the molding with a clean rag using Varnish
Makers and Painters (VMP) naphtha.
2. If needed apply a length of masking tape as a molding guide. A straightedge may also be used.
3. To install a loose molding end, heat the molding and panel using a J 25070
Apply heat using a circular motion for about 30 seconds.
4. Apply the adhesive to the back of the molding and press in place. If the adhesive GM P/N 1052621 or equivalent is used apply constant pressure
to the molding for 30 seconds or until a firm bond has been made.
Front Fascia Molding Replacement
1. To remove the molding, heat the molding using a J 25070
Apply heat using a circular motion for about 30 seconds.
Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.
2. Use a plastic, flat-bladed tool to lift or remove the molding from the panel surface.
