Lumina V6-3.1L VIN J (2000)
32. When using the extended method, use the edge of the windshield window or the inside edge of the reveal molding as a guide for the nozzle in
order to apply the urethane adhesive (1) to the inner surface of the windshield window (3).
If applying urethane adhesive to the inside edge of the windshield reveal molding (1) use the windshield reveal molding as a guide for the nozzle.
33. With the aid of an assistant, use suction cups in order to install the windshield into the opening.
34. Align the tape lines (1) on the windshield and the body.
35. Press the windshield firmly into place.
36. Tape the windshield to the body in order to minimize movement until the urethane adhesive cures.
37. Clean any excess urethane adhesive from the body.
Important: Do not direct a hard stream of high pressure water to the freshly applied urethane adhesive.
38. Use a soft spray of warm water in order to immediately water test the windshield window.
39. Inspect the windshield for leaks.
40. If any leaks are found, use a plastic paddle in order to apply extra urethane adhesive at the leak point.
41. Retest the windshield for leaks.
42. The following conditions must be maintained to properly cure the urethane:
43. Allow the vehicle to remain at room temperature (21°C or 70°F) at 30 percent relative humidity.
