Lumina V6-3.1L VIN J (2000)
Ash Tray: Removal and Replacement
Ashtray Replacement
Removal Procedure
1. Remove the instrument panel (IP) cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement (See: Instrument Panel, Gauges and
Warning Indicators/Instrument Cluster / Carrier/Service and Repair/Instrument Cluster Trim Panel Replacement) .
2. Remove the IP ashtray (4).
3. Remove the IP ashtray bracket screws.
4. Remove the IP ashtray bracket (2) from the IP.
5. Disconnect the electrical connector.
Installation Procedure
1. Connect the electrical connector.
2. Install the instrument panel (IP) ashtray bracket (2) to the IP.
Notice: Refer to Fastener Notice in Cautions and Notices.
3. Install the IP ashtray bracket screws.
Tighten the IP ashtray bracket screws to 1.9 N.m (17 lb in).
4. Install the IP ashtray (4).
5. Install the IP cluster trim plate. Refer to Instrument Cluster Trim Panel Replacement (See: Instrument Panel, Gauges and Warning
Indicators/Instrument Cluster / Carrier/Service and Repair/Instrument Cluster Trim Panel Replacement) .