Lumina V6-3.1L VIN J (2000)
-
The pistons on the ABS brake modulator will be positioned very close to the top of the modulator bore.
-
The brake bleeding procedure becomes simplified. Refer to Hydraulic Brake System Bleeding.
Important: Use care when handling the motor packs. Replace the motor packs if the motor packs are dropped or damaged during handling.
Align each of the three motor pack pinions with the modulator gears.
2. Install the motor pack (1) to the modulator assembly (6).
Notice: Refer to Fastener Notice in Service Precautions.
3. Install four Torx head screws (4).
-
Tighten the Toe head screws to 4.5 Nm (40 inch lbs.).
4. Install the gear cover (3) onto the modulator/brake master cylinder assembly. Refer to Modulator Gear Cover Replacement.
