Lumina V6-3.1L VIN J (2000)
Wheel Speed Sensor: Technical Service Bulletins
ABS/TCS - Revised Front Wheel Speed Sensor Replacement
Bulletin No.: 05-05-25-006
Date: September 16, 2005
SERVICE MANUAL UPDATE
Subject:
Revised Front Wheel Speed Sensor Replacement Procedure
Models:
1997-1999 Chevrolet Monte Carlo
1997-2001 Chevrolet Lumina
This bulletin is being issued to revise the Front Wheel Speed Sensor Replacement procedure in the ABS/Traction Control sub-section of the Service
Manual. Please replace the current information in the Service Manual with the following information.
The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin
on the affected page.
Wheel Speed Sensor Replacement (Front)
Removal Procedure
Important:
The front sensor is serviceable only as an assembly. DO NOT attempt to service the sensor harness pigtail as it is part of the sensor.
1.
Raise and support the vehicle.
2.
Disconnect the front electrical connector.
3.
Remove the bolt retaining the sensor pigtail wire.
4.
Remove the 2 bolts retaining sensor to the steering knuckle.
5.
Remove the sensor.
Installation Procedure
