Lumina V6-3.1L VIN J (2000)
Coolant Filler Neck: All Technical Service Bulletins
Radiator - Brown Substance On Cap & Upper Filler Neck
File In Section: 06 - Engine/Propulsion System
Bulletin No.: 00-06-02-004
Date: May, 2000
TECHNICAL
Subject:
Brown Colored Gel-Like Substance on Radiator Cap and Upper Filler Neck (Replace Radiator Cap and Clean Radiator Upper Filler Neck)
Models:
1997-2000 Buick Century
1996
Chevrolet Lumina APV
1996-2000 Chevrolet Lumina, Monte Carlo
1997-2000 Chevrolet Venture
2000
Chevrolet Impala
1996-1997 Oldsmobile Cutlass Supreme
1996-2000 Oldsmobile Silhouette
1996-1997 Pontiac Trans Sport
1996-2000 Pontiac Grand Prix
1998-2000 Pontiac Montana
with 3.1L or 3.4L Engine (VINs J, M, E, X - RPOs LG8, L82, LA1, LQ1)
Condition
Some customers may comment about a brown colored gel-like substance on the radiator cap and upper filler neck.
Correction
Important:
This condition is unique to the 3.1L and 3.4L engines and should not be confused with the condition described in Corporate Bulletin Number
99-06-02-012B - Rust in Coolant System.
This condition is almost always confined to the radiator cap and upper filler neck, so it is not necessary to change the coolant. keeping the cooling system
full at all times should eliminate future recurrence. Replace the radiator cap and clean the radiator upper filler neck using the procedure and part numbers
listed below.
1.
Remove the radiator cap when the engine is cool.
^
Slowly rotate the cap counterclockwise to detent. Do not press down while rotating the pressure cap.
^
Wait until any residual pressure (indicated by a hissing sound) is relieved.
^
After all hissing stops, continue to rotate counterclockwise until the cap is removed.
2.
Using a shop rag, clean the upper radiator filler neck of any residue.
3.
Remove the coolant recovery reservoir if visually contaminated. Refer to the Coolant Recovery Reservoir Replacement procedure in the Engine
Cooling sub-section of the appropriate Service Manual.
4.
If necessary, clean the coolant recovery reservoir and all hoses attached to it with soap and water. Rinse the reservoir and hoses with clean water
and drain.
Verify that the coolant can flow freely through the hoses.
5.
Install the coolant recovery reservoir. Refer to the Coolant Recovery Reservoir Replacement procedure in the Engine Cooling sub-section of the
appropriate Service Manual.
6.
Refill the coolant recovery reservoir with a 50/50 mixture of DEX-COOL(R) and clean drinkable or distilled water to the HOT mark. Fill to the
HOT mark to compensate for any air that may be in the cooling system.
7.
Fill the radiator to the top of the filler neck.
