Lumina V6-3.1L VIN J (2000)
6. Connect the heater outlet hose (2) to the thermostat bypass pipe.
7. Connect the throttle body inlet (3) and outlet (4) hoses to the thermostat bypass pipe (1).
8. Install the AIR pipe.
9. Connect the inlet hose at the thermostat housing.
10. Use the J38185 in order to reposition and install the inlet hose clamp at the thermostat housing.
11. Install the left bank spark plugs wires. Refer to Spark Plug Wire Harness Replacement.
12. Install the LH engine mount strut. Refer to Engine Mount Strut Replacement (Left).
13. Carefully install the throttle body air inlet duct. Refer to Powertrain Management.
14. Fill the cooling system. Refer to Draining and Filling Cooling System in Cooling System.
15. Inspect for leaks.
