Lumina V6-3.1L VIN J (2000)
1. Install the engine mount bracket to the engine mount.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the engine mount upper nuts.
Tighten the engine mount upper nuts to 47 Nm (35 ft. lbs.).
3. Lower the engine.
4. Install the engine mount bracket to the oil pan.
5. Install the engine mount bracket-to-oil pan bolts.
Tighten the engine mount bracket bolts to 58 Nm (43 ft. lbs.).
6. Install the right engine splash shield. Refer to Splash Shield Replacement - Engine in Body and Frame.
7. Install the right front wheel and tire. Refer to Tire and Wheel Removal and Installation in Steering and Suspension.
8. Connect the three-way catalytic converter pipe to the right (rear) exhaust manifold. Refer to Catalytic Converter Replacement in Powertrain
Management.
9. Lower the vehicle.
10. Remove the J28467-B and the J36462-A, and the J28467-9OA.
11. Install the engine mount struts. Refer to Engine Mount Strut Bracket Replacement (Left) and Engine Mount Strut Bracket Replacement (Right).
12. Install the throttle body air inlet duct.
13. Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure.
