Lumina V6-3.1L VIN J (2000)
Engine Mount: Service and Repair
Engine Mount Bracket Replacement
Removal Procedure
-
Tools Required
-
J28467-9OA Engine Support Adapters
-
J28467-B Universal Engine Support Fixture
-
J36462-A Engine Support Adapter Leg Set
1. Disconnect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure.
2. Remove the throttle body air inlet duct.
3. Remove the engine mount struts. Refer to Engine Mount Strut Bracket Replacement (Left) and Engine Mount Strut Bracket Replacement (Right).
4. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
5. Remove the three-way catalytic converter pipe from the right (rear) exhaust manifold. Refer to Catalytic Converter Replacement in Powertrain
Management.
6. Remove the right front wheel and tire. Refer to Tire and Wheel Removal and Installation in Steering and Suspension.
7. Remove the right engine splash shield. Refer to Splash Shield Replacement - Engine in Body and Frame.
8. Remove the engine mount bracket-to-oil pan bolts.
9. Remove the engine mount upper nuts.
10. Remove the engine mount bracket from the engine mount.
Installation Procedure