Lumina V6-3.1L VIN J (2000)
Oil Pressure Sensor: Service and Repair
REMOVAL PROCEDURE
1. Turn OFF the ignition switch.
2. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in general information.
3. Disconnect the electrical connector from the engine oil pressure sensor.
4. Remove the engine oil pressure sensor.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Cautions and Notices.
1. Install the engine oil pressure sensor.
Tighten
The oil pressure sensor to 16 Nm (12 lb in.)
2. Connect the electrical connector to the engine oil pressure sensor.
3. Lower the vehicle.