Lumina V6-3.1L VIN J (2000)
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the exhaust crossover pipe bolts.
Tighten the exhaust crossover pipe bolts to 25 Nm (18 ft. lbs.).
3. Install the exhaust crossover heat shield.
4. Install the exhaust crossover heat shield bolts.
Tighten the exhaust crossover heat shield bolts to 10 Nm (89 inch lbs.).
5. Install the throttle body air inlet duct.
6. Connect the battery ground (negative) cable. Refer to Battery Negative Cable Disconnect/Connect Procedure.
