Lumina V6-3.1L VIN J (2000)
1. Verify that the shift shaft in the Neutral position.
Important: DO NOT ROTATE A NEW PNP SWITCH. A new PNP switch is pinned in the Neutral position. If the bolt holes do not align with the
mounting boss on the transaxle, verify that the shaft is in the Neutral position.
Adjust the PNP switch if the new switch has been rotated and the pin is broken or if using an old PNP switch. Refer to PNP Switch Adjustment.
2. Align the flats of the shift shaft to the flats in the PNP switch.
3. Install the PNP switch to the mounting boss.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the PNP switch mounting bolts.
Tighten the PNP switch mounting bolts to 25 Nm (18 ft. lbs.).
5. Install the automatic transaxle range selector lever. Refer to Automatic Transmission Range Selector Cable Lever Replacement.
6. Install the wiring harness connectors.
