Lumina V6-3.1L VIN J (2000)
interrupter) is repeatedly moved in and out of the air gap, the signal voltage will appear to go on-off, on-off, on-off. Compared to a conventional
mechanical distributor, this on-off signal is similar to the signal that a set of breaker points in the distributor would generate as the distributor shaft
turned and the points opened and closed.
In the case of the electronic ignition system, the piece of steel is a concentric interrupter ring mounted to the rear of the crankshaft balancer. The
interrupter ring has blades and windows that, with crankshaft rotation, either block the magnetic field or allow it to reach the Hall-effect switch. The
Hall-effect switch is called a 24X crankshaft position sensor, because the interrupter ring has 24 evenly spaced blades and windows. The 24X crankshaft
position sensor produces 24 on-off pulses per crankshaft revolution.
The interrupter ring is a special wheel cast on the crankshaft that has seven machined slots, six of which are equally spaced 60 degrees apart. The
seventh slot is spaced 10 degrees from one of the other slots, as the interrupter ring rotates with the crankshaft, the slots change the magnetic field. This
will cause the 7X to ground the 3X signal voltage that is supplied by the ignition control module. The ignition control module interprets the 7X on-off
signals as an indication of crankshaft position. The ignition control module must have the 7X signal to fire the correct ignition coil.
The 7X interrupter ring and Hall-effect switch react similarly. The 24X signal is used for better resolution at a calibrated RPM.
