Lumina V6-3.1L VIN J (2000)
25. Bend flat the twisted connection.
26. Secure and insulate the connection using electrical tape.
27. Twist together, bend, and tape the remaining connector wire lead to the remaining deployment wire.
28. Connect the deployment harness to the inflatable restraint IP module yellow 2-way connector.
29. Route the deployment harness out of the passenger side of the vehicle.
30. Clear the inside and outside of the vehicle of any people or loose and flammable objects.
31. Stretch the driver harness to full length.
32. Stretch the passenger harness to full length.
33. Completely cover the windshield and front door window openings with a drop cloth.
34. Place a power source, 12 V minimum/2 A minimum (i.e., a vehicle battery) near the shorted end of the harness.
35. Separate the two ends of the driver deployment harness wires.
36. Connect the driver deployment harness wires to the power source in order to deploy the inflatable restraint steering wheel module.
37. Disconnect the driver deployment harness wires from the power source.
38. Separate the two ends of the passenger deployment harness wires.
