Lumina V6-3.1L VIN J (2000)
Steering Gear: Service and Repair
Rack and Pinion Boot and Breather Tube Replacement (Off Vehicle)
Disassembly Procedure
-
Tools Required
-
J 22610 Service Boot Clamp Installer
1. To remove the outer tie rod; refer to Tie Rod End Replacement - Outer - Off Vehicle.
2. Remove the hex jam nut (2) from the inner tie rod assembly (1).
3. Remove the tie rod end clamp (2) from the rack and pinion boot (1).
4. Remove the boot clamp (1) from the rack and pinion boot (3) with side cutters.
5. Discard the boot clamp (1).
Important: Prior to removing breather tube (2) or rack and pinion boot (3), mark the location of the breather tube (2) on the gear assembly.
6. Remove the rack and pinion boot (3) and the breather tube (2).
Assembly Procedure