Lumina V6-3.1L VIN J (2000)
1. Route the SIR connector through the steering wheel (2).
2. Align the scribe mark on the steering wheel (2) with the slash mark on the steering shaft.
3. Install the steering wheel (2).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the steering wheel shaft nut (1).
-
Tighten the steering wheel shaft nut to 45 Nm (33 ft. lbs.).
5. Install the inflator module.
6. Enable the SIR system.
7. Inspect the operation of the following components:
-
The horn
-
The steering wheel (2)