Lumina V6-3.1L VIN J (2000)
4. Loosely install the NEW rear frame-to-body bolts.
5. Loosely install the NEW front frame-to-body bolts.
Notice: Refer to Fastener Notice in Cautions and Notices.
6. Align the frame to the body by inserting two 19 X 203 mm (0.74 X 8.0 in) pins in the alignment holes on the right side of the frame.
Tighten the frame bolts to 180 N.m (133 lb ft).
7. Connect both the lower ball joints to the lower control arms. Refer to Lower Control Arm Ball Joint Replacement.
8. Install the engine mount-to-frame nuts. Refer to Engine Mount Replacement.
9. Install the transaxle mount-to-frame nuts. Refer to Transmission Mount Replacement.
10. Install the steering gear mounting bolts. Refer to Steering Gear Replacement.
11. Connect both front wheel speed sensor connectors (1).
12. Install both front wheel speed harness retainers (2) to the frame and the lower control arm.
13. Install the power steering cooler pipe. Refer to Power Steering Cooler Pipe/Hose Replacement.
14. Install the front tires and wheels. Refer to Tire and Wheel Removal and Installation.
15. Lower the vehicle.
16. Remove the engine support fixture. Refer to Engine Mount Replacement.
