Lumina V6-3.1L VIN J (2000)
8. Use the J 28733-B in order to push the axle splines back out of the hub/bearing.
Important: Protect the axle seals (boots) from damage during handling.
9. Remove the hub/bearing to knuckle attaching bolts.
10. Remove the ABS sensor mounting bolt and position the ABS sensor aside in order to prevent damage.
11. Remove the hub/bearing.
12. Inspect all components for wear or damage.
Installation Procedure
1. Install the hub/bearing onto the axle shaft splines.
2. Install the knuckle to hub/bearing attaching bolts.
3. Properly position the ABS sensor and install the mounting bolt.
4. Install the following components:
5. Install the rotor (4).
6. Install the brake caliper and mounting bracket (5).