Lumina V6-3.1L VIN J (2000)
3. Install the wiper drive system module onto the vehicle with three screws.
Tighten
Tighten three screws to 12 N.m (106 lb in).
4. Connect the two connectors to the wiper motor assembly.
5. Install two retainers in the connectors.
6. Install the air inlet grille panel.
7. Install the wiper arms onto the vehicle.
INSPECTION PROCEDURE
^
Inspect the park position. Both wiper arms must be against the park ramps.
^
Inspect the wipe pattern. The dimension should be 55-132 mm (2.17-5.20 in) from the top of the driver's side wiper blade assembly on the
outerwipe to the edge of the glass.
^
The correct park position and outerwipe dimension are determined with the wipers operating at low speed on wet glass.
