Lumina V6-3.8L VIN K (1998)
^
The pistons on the ABS brake modulator will be positioned very close to the top of the modulator bore.
^
The pistons on the TCS modulator will be positioned very close to the bottom of the modulator bore.
^
The brake bleeding procedure becomes simplified.
IMPORTANT: Use care when handling the motor packs. Replace the motor packs if the motor packs are dropped or damaged during handling.
Align each of the three motor pack pinions (two are on the TCS) with the modulator gears.
2. Install the motor pack (1 ) to the modulator assembly (6).
3. Install four Torx head screws (4).
^
Tighten the Torx head screws to 4.5 Nm (40 inch lbs.) .
NOTICE: Refer to Fastener Notice in Cautions and Notices.
4. Install the gear cover (3) onto the modulator/brake master cylinder assembly.
