Lumina V6-3.8L VIN K (1998)
2. Install the exhaust muffler inlet pipe clamp to the original exhaust mufflers. Do not tighten the exhaust muffler inlet pipe clamp nut.
3. Install the catalytic converter bolts. Do not tighten the catalytic converter bolts.
4. Install the insulators to the exhaust pipe.
^
Tighten the exhaust muffler inlet pipe clamp nuts to 50 Nm (37 ft. lbs.).
^
Tighten the catalytic converter bolts to 45 Nm (33 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Lower the vehicle.
