Lumina V6-3.8L VIN K (1998)
Headlamp Bulb: Service and Repair
The low-beam and high-beam headlamp bulbs can be replaced without removal of the headlamp. Refer to Replacement Bulbs for the correct bulb
usage.
CAUTION:
^
Halogen bulbs contain a gas under pressure. Handling a bulb improperly could cause It to shatter into flying glass fragments. To help
avoid personal injury:
^
Turn off the light switch and allow bulb to cool before changing bulbs. Leave the switch off until the bulb change is complete.
^
Always wear eye protection when changing a halogen bulb.
^
Handle the bulb only by its base. Avoid touching the glass.
^
Do not drop or scratch the bulb.
^
Keep moisture away.
^
Place the used bulb in the new bulb's carton and dispose of it properly. Keep halogen bulbs out of the reach of children.
^
Before removing or installing any electrical unit(s), disconnect the negative battery cable to help prevent personal injury and/or damage
to the vehicle or its components.
^
This vehicle has a Supplemental Inflatable Restraint (SIR) System. Refer to the SIR Component and Wiring Location view in order to
determine whether you are performing service on or near the SIR component or the SIR wiring. When you are performing service on or
near the SIR components or the SIR wiring, refer to the SIR On-Vehicle Service information. Failure to follow the CAUTIONS could
cause air bag deployment, personal injury, or unnecessary SIR system repairs.
REMOVE OR DISCONNECT
1. Radiator air upper baffle.
2. Socket and bulb from headlamp.
3. Bulb from socket.
INSTALL OR CONNECT
1. Bulb to socket.
2. Socket with bulb to headlamp.
3. Radiator air upper baffle.
