Lumina V6-3.8L VIN K (1998)
Trunk Lamp: Service and Repair
Rear Compartment Lamp Replacement
REMOVE OR DISCONNECT
1. Open rear compartment.
2. Bolt/screw from ground wire.
3. Rear compartment lamp by sliding the clip loose.
4. Slide the clip loose holding the connector.
5. Electrical connector.
INSTALL OR CONNECT
1. Electrical connector.
2. Connector clip onto rear compartment lid.
3. Rear compartment lamp by sliding clip onto rear compartment lid.
4. Bolt/screw to ground wire.
Tighten
^
Bolt/screw to 3 N.m (27 lb. in.).