Lumina V6-3.8L VIN K (1998)
Power Steering Line/Hose: Service and Repair
PWR Str Fluid Cooling Pipe and Reservoir Inlet Hose (Ret Line)
Power Steering Hose (Part 1 Of 2)
Power Steering Hose/Pipe Routing (Part 2 Of 2)
Remove or Disconnect
1. Place drain pan under pump and gear.
2. Engine mount strut at engine.
3. Reservoir inlet hose from pump.
4. Tie straps from hose.
5. Raise vehicle and suitably support.
CAUTION: Failure to disconnect intermediate shaft from rack and pinion stub shaft can result in damage to steering gear and/or
intermediate shaft. This damage can cause loss of steering control which could result in personal injury.
NOTICE: Set steering shaft so block tooth on upper steering shaft is at the 12 o'clock position, wheels on vehicle are straight ahead and set
ignition switch to LOCK position. Failure to follow these procedures could result in damage to the coil.
